Gorilla Glue 5 Min 2-Part Epoxy Syringe 25ml - GRGGES25

Product Overview:

The crystal clear, gap filling, two-part adhesive.

Gorilla Epoxy delivers a strong, long-lasting bond to both household and automotive repairs. The easy-to-use syringe dispenses an equal amount of resin and hardener, that when mixed together creates a permanent, durable and water resistant bond. The two-part, gap-filling Gorilla Epoxy formula sets in 5 minutes and easily bonds steel, aluminium, glass, wood, ceramic, tile and most plastics*. Plus it dries crystal clear, ensuring your projects look spotless. *Not recommended for use on polyethylene or polypropylene plastic or similar materials

Product Benefits:

• High Strength
• Sets in 5 Mins
• Water Resistant
• Bond Withstands Extreme Temperatures

The Gorilla Glue 5 Min 2-Part Epoxy Syringe has an impact-tough formula, using hybrid technology to improve overall adhesion, strength, and flexibility. It fills voids and bonds on uneven and vertical surfaces, with a 5-minute set time, allowing time for repositioning.
The epoxy withstands moderate exposure to water and will not break down from exposure to common solvents. It has a low VOC and is non-toxic once cured, safe for everyday handling, dries clear and is ideal for a clean easy finish.

How to use

PREPARATION
All surfaces to be bonded should be clean and dry. To improve adhesion, roughen smooth surfaces with sandpaper before gluing. Ensure your work area is well-ventilated and protected from spills.

Remove stir stick from middle of plunger. With nozzle pointing upward, snap the sealing cap off the syringe then eliminate any air by slowly pushing plunger until resin and hardener reach the tip.

1. DISPENSE & MIX
Dispense resin and hardener onto a clean, disposable surface until they are both flowing equally. Even amounts of the resin and hardener can then be dispensed into a disposable mixing tray.

The package blister can be used as a mixing tray for the first use. Stir the mixture for at least 20 seconds, until it is uniform. As you mix, you will notice that the epoxy warms up – this is a reaction that occurs as the resin and hardener combine.

2. APPLY
Apply mixture to surface within 5 minutes. Bond strength will decrease the longer you wait to apply. Remove any excess glue immediately from project surface with a dry cloth.

3. GRIP
To achieve maximum bond strength, clamp surfaces together and leave undisturbed for 30 minutes.

Full cure achieved in 24 hours.